Transfer Curve

curve · v1

Linearly interpolates a Number using ordered transfer-curve points.

Transfer Curve

Inputs

Outputs

Select a port to see its purpose and an example connection. Its reference row will highlight.

Ports and connections

Port / ID	Type	Connection
Value`value`	number	Controls Value with a number stream. Without a wire, the manual value is 0.Manual value when disconnected
Output`out`	number	The number result of Transfer Curve, available to other nodes on every sample.Output

An output can feed multiple inputs of the same type. An input has one source; Function also requires matching signatures. All connection rules →

Parameters

Values describe manual settings. A connected stream replaces a parameter’s manual value; disconnecting restores it.

Parameter	Range	Default	Control
Value`value`	-1000000…1000000	0	Input or manualLinear scale

Node properties

These settings are configured before compilation and cannot be modulated by wires.

Curve points: Default (−1, −1), (0, 0), (1, 1)
Edit curve points: 2…4096 X/Y pairs; X must strictly increase and all values must be finite.

How to use it

Set points (−1, −0.5), (0, 0), (1, 0.5): Value = 0.5 gives 0.25.

Things to check

Enter x,y pairs with increasing x. Values outside the curve hold the endpoint values.

Check required inputs and matching types. Run Compile before auditioning; a validation failure preserves the previous working module. Troubleshooting →