Node Input
subgraph_input · v1Represents a custom node’s input inside its graph. Type, range and default come from the subgraph interface.
Defined by the project
Ports and connections
The default configuration is shown below. Types and capacity can change in node properties; configure the node before connecting ports.
| Port / ID | Type | Connection |
|---|---|---|
Outputout | number | The number result of Node Input, available to other nodes on every sample.OutputCapacity: 64 |
An output can feed multiple inputs of the same type. An input has one source; Function also requires matching signatures. All connection rules →
Parameters
Values describe manual settings. A connected stream replaces a parameter’s manual value; disconnecting restores it.
| Parameter | Range | Default | Control |
|---|---|---|---|
Defaultdefault | -1000000…1000000 | 0 | StaticLinear scale |
Node properties
These settings are configured before compilation and cannot be modulated by wires.
- Port definition
- Configured through the parent node’s Edit ports
Type, default, range, capacity and signature match the external port by its stable ID. The port table shows the initial Number configuration.
How to use it
Number port Cutoff → Node Input → Biquad Coefficients / Frequency.
Things to check
Use this inside a Custom Node, not in place of the top-level Input.
Check required inputs and matching types. Run Compile before auditioning; a validation failure preserves the previous working module. Troubleshooting →